Pix

From Internetworkpro

This page is currently in progress and is not completed Please note that the information on this page is pending completion by the author. You can help contribute by using the edit tab above. See where else you can help at Category:InProgress

This page or section has been marked as requiring improvement. Please review this page or section and make any stylistic or grammar changes necessary to improve the article. For assistance, please check the Page Guidelines. To discuss improvement of the article, use the talk page. Other articles in need of improvement can be found at Category:Needs Improvement

PIX and ASA resource

INTRO:

As well as in a router, you start at unprivilegied mode:
pixfirewall>
The "pixfirewall" is the default hostname of PIX.
pixfirewall> enable
password:
If it is the first time that you are loggin in, the password is in black.
pixfirewall#
Above prompted will be showed after you enter in privilegied mode. (If you know a little bit about cisco routers it isn't new for you).
pixfirewall#cofigure terminal
To go to global mode.And finally lets change the hostname:
pixfirewall(config)#hostname pix1
pix1(config)#

Hey, pay attention, the hostname had been changed!